Cisco 640-816 Actual Questions, The Best Cisco 640-816 Question Description With The Knowledge And Skills

FLYDUMPS is your premier source of Cisco 640-816 Exam for Storage Administrators. With FLYDUMPS Cisco 640-816 exam sample questions, no other vendor will be able to compare to quality Cisco 640-816 test. FLYDUMPS Cisco 640-816 Training is always updated to provide you the most actual information available and this is done with the help of FLYDUMPS professional team of certification experts, technical staff, and comprehensive language masters who are always in-touch with the changes in the Cisco 640-816 exam. So the true way for passing the Cisco 640-816 Exam for Storage Administrators is to get in touch with FLYDUMPS, Cisco 640-816 exam sample questions will lead to your Cisco 640-816 Certification success.

A company with 25 computers decides to connect its network to the Internet. The company would like for all of the computers to have access to the Internet at the same time, but the company only has four usable public IP addresses. What should be configured on the router so that all computers can connect to the Internet simultaneously?
A. static NAT
B. global NAT
C. dynamic NAT
D. static NAT with ACLs
E. dynamic NAT with overload

Correct Answer: E
Which access list statement will block all traffic with a destination TCP port number of 5190 while not affecting other traffic?
A. access-list 180 deny tcp any any eq 5190
B. access-list 180 deny tcp any eq 5190 any
C. access-list 180 deny ip any eq 5190 any
D. access-list 180 deny tcp any eq 5190
E. access-list 180 deny telnet any any 5190

Correct Answer: A
Refer to the exhibit. Serial0/0 does not respond to a ping request from a host on the FastEthernet0/0 LAN. How can this problem be corrected?

A. Enable the Serial 0/0 interface.
B. Correct the IP address for Serial 0/0.
C. Correct the IP address for FastEthernet 0/0.
D. Change the encapsulation type on Serial 0/0.
E. Enable autoconfiguration on the Serial 0/0 interface.

Correct Answer: A
A network administrator wants to ensure that only the server can connect to port Fa0/1 on a Catalyst switch. The server is plugged into the switch Fa0/1 port and the network administrator is about to bring the server online. What can the administrator do to ensure that only the MAC address of the server is allowed by switch port Fa0/1? (Choose two.)
A. Configure port Fa0/1 to accept connections only from the static IP address of the server.
B. Employ a proprietary connector type on Fa0/1 that is incompatible with other host connectors.
C. Configure the MAC address of the server as a static entry associated with port Fa0/1.
D. Bind the IP address of the server to its MAC address on the switch to prevent other hosts from spoofing the server IP address.
E. Configure port security on Fa0/1 to reject traffic with a source MAC address other than that Build Your Dreams PassGuide 640-816 of the server.
F. Configure an access list on the switch to deny server traffic from entering any port other than Fa0/1.

Correct Answer: CE
If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface?
A. the IP address of the first Fast Ethernet interface
B. the IP address of the console management interface
C. the highest IP address among its active interfaces
D. the lowest IP address among its active interfaces
E. the priority value until a loopback interface is configured

Correct Answer: C
Which protocol should be used to establish a secure terminal connection to a remote network device?
C. Telnet
Correct Answer: B
What can a network administrator utilize by using PPP Layer 2 encapsulation? (Choose three.)
A. VLAN support
B. compression
C. authentication
D. sliding windows
E. multilink support
F. quality of service
Correct Answer: BCE QUESTION 113
Build Your Dreams PassGuide 640-816
Refer to the exhibit. The following commands are executed on interface fa0/1 of 2950Switch. 2950Switch(config-if)# switchport port-security 2950Switch(config-if)# switchport port-security mac-address sticky 2950Switch(config-if)# switchport port-security maximum 1 The Ethernet frame that is shown arrives on interface fa0/1. What two functions will occur when this frame is received by 2950Switch? (Choose two.)

A. The MAC address table will now have an additional entry of fa0/1 FFFF.FFFF.FFFF.
B. Only host A will be allowed to transmit frames on fa0/1.
C. This frame will be discarded when it is received by 2950Switch.
D. All frames arriving on 2950Switch with a destination of 0000.00aa.aaaa will be forwarded out fa0/1.
E. Hosts B and C may forward frames out fa0/1 but frames arriving from other switches will not be forwarded out fa0/1.
F.     Only frames from source 0000.00bb.bbbb, the first learned MAC address of 2950Switch, will be forwarded out fa0/1.

Correct Answer: BD
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link. The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?
Build Your Dreams PassGuide 640-816

A. The OSPF area is not configured properly.
B. The priority on R1 should be set higher.
C. The cost on R1 should be set higher.
D. The hello and dead timers are not configured properly.
E. A backup designated router needs to be added to the network.
F. The OSPF process ID numbers must match.

Correct Answer: D
Refer to the topology and command output within the exhibit. When hosts on the network attempt to ping the remote server at, the message “Reply from expired in transit” is returned. What is the cause of this problem?

A. No static route is configured on the SOHO router to the network.
B. No static route is configured on the ISP router to the network.
C. A routing protocol must be configured to send packets between SOHO and ISP.
D. A routing loop has occurred.

Correct Answer: D
Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume
the discarding role?

A. Switch3, port fa0/1
B. Switch3, port fa0/12
C. Switch4, port fa0/11
D. Switch4, port fa0/2
E. Switch3, port Gi0/1
F. Switch3, port Gi0/2

Correct Answer: C
Which routing protocol by default uses bandwidth and delay as metrics?
Correct Answer: D provide the best training material for Cisco 640-816 certification exams. When you use our products Flydumps ensure that you emerge successful in your certification exam. We provide with the latest Cisco 640-816 exam dumps, you can easily pass your certification exam with our exam dumps.