Cisco 351-080 Exam Guide, Buy Best Cisco 351-080 Real Testing Latest Version PDF&VCE

QUESTION 50
On an MDS switch, which command must be configured after the zonesets have been created or changed, so that they will take effect?
A. zoneset start name <name> vsan <vsan#>
B. zoneset move name <name> vsan <vsan#>
C. zoneset activate name <name> vsan <vsan#>
D. zoneset trigger name <name> vsan <vsan#>

Correct Answer: C
QUESTION 51
Which statement is true about FCIP configuration on Cisco MDS switches?
A. The source and destination IP addresses of the FCIP tunnel are configured under the FCIP interface.
B. The source and destination IP addresses of the FCIP tunnel are configured under the FCIP profile. “Pass Any Exam. Any Time.” – www.actualtests.com 25 Cisco 351-080 Exam
C. The source and destination IP addresses of the FCIP tunnel are configured under the physical Ethernet interface.
D. The source IP address of the FCIP tunnel is configured under the FCIP profile, and the destination IP address is configured under the FCIP interface.
E. The source IP address of the FCIP tunnel is configured under the FCIP interface, and the destination IP address is configured under the FCIP profile.
Correct Answer: D
QUESTION 52
Which two statements about features of Cisco FCIP are true? (Choose two.)
A. The FCIP link consists of two TCP connections.
B. iSCSI can be used over FCIP.
C. The default TCP port that is used on connections is 3225.
D. Endpoint pWWNs are required for the FCIP profile.
E. Class F frames are sent out of band.

Correct Answer: AC QUESTION 53
Fibre Channel extension using FCIP provides which three capabilities to a deployed data center? (Choose three.)
A. ISL e-port between MDS switches
B. both sync and async applications use a single VSAN with no trunking
C. FSPF routing
D. 2-Gb Fibre Channel transport

Correct Answer: ABC QUESTION 54
Refer to the exhibit.
“Pass Any Exam. Any Time.” – www.actualtests.com 26 Cisco 351-080 Exam

Which port type should there be on the NPV edge switch?
A. NP Port
B. F Port
C. N Port
D. FE Port

Correct Answer: A QUESTION 55
Which three statements are false about NPV? (Choose three.)
“Pass Any Exam. Any Time.” – www.actualtests.com 27 Cisco 351-080 Exam
A. Port security is not supported for device login into the core via NPV.
B. In certain cases, local switching is supported.
C. There can be up to 100 NPV devices.
D. The only two port types that are supported in NPV mode are F Ports and NP Ports.
E. Remote SPAN is not supported.

Correct Answer: ABD QUESTION 56
Refer to the command that is shown below. A host that is connected to the NPV switch is not able to see the storage that is connected to the core switch. What is the most likely reason for this problem? Switch# show npv status npiv is enabled External Interfaces: ==================== InterfacE. fc1/1, VSAN: 1, FCID. 0x000000, State: Other Number of External Interfaces: 4
A. NPV is not enabled on the core switch.
B. The interface that is connected to the core switch is in an “admin down” state.
C. The local host interface belongs to the wrong VSAN.
D. The local host interface is not able to log in.

Correct Answer: B QUESTION 57
“Pass Any Exam. Any Time.” – www.actualtests.com 28 Cisco 351-080 Exam Refer to the exhibit.

Which FCIP operation does the network diagram represent?
A. connection setup
B. write acceleration
C. connection teardown
D. transfer ready

Correct Answer: B QUESTION 58
Refer to the exhibit.

“Pass Any Exam. Any Time.” – www.actualtests.com 29 Cisco 351-080 Exam Which of the following port types map to the ports on the network diagram that are indicated with a question mark?
A. VE and TE
B. E and TE
C. P and E
D. NPV and NPIV

Correct Answer: B QUESTION 59
Which three statements are true about iSCSI and FCIP? (Choose three.)
A. FCIP and iSCSI are solutions for enabling access to storage.
B. With FCIP, SCSI commands and data frames are encapsulated in IP.
C. With iSCSI, SCSI commands and data frames are encapsulated in IP.
D. FCIP can transport both SCSI and non-SCSI frames.
E. FCIP allows IP-connected hosts to access storage.

Correct Answer: ACD
QUESTION 60
Which three statements are true about VE Ports and TE Ports? (Choose three.)
A. VE Ports are used to “expand” a Fibre Channel fabric by connecting multiple Fibre Channel switches together.
B. VE Ports are used to “expand” an FCoE fabric by connecting multiple FCoE switches together.
C. TE Ports are “trunking” E Ports that transport multiple VSANs over the same ISL.
D. VE Ports run between two FCoE capable switches.
E. TE Ports run between two FCoE capable switches.

Correct Answer: BCD
QUESTION 61
Which two statements are true about NPIV? (Choose two.)
A. NPIV stands for N-Port ID Virtualization.
B. NPIV stands for N-Port Interface Virtualization.
C. NPIV assigns many client ports to one ID.
D. NPIV assigns many IDs to one client port.

Correct Answer: AD
QUESTION 62
Which type of port provides multihop FCoE connections between FCoE capable switches?
A. F Port
B. N Port
C. E Port
D. VE Port
E. TE Port

Correct Answer: D
QUESTION 63
In a Cisco Nexus 5000 switch, each system class has an associated IEEE 802.1p CoS value that is assigned by default or configured on the system class. If you enable PFC, the switch sends the no-drop CoS values to the adapter, which then applies PFC to these CoS values.
What is the default CoS value for the FCoE system class?
A. 5
B. 3
C. 0
D. 7
Correct Answer: B QUESTION 64
It is possible to run multiple VEMs per hypervisor host.
A. True
B. False

Correct Answer: B QUESTION 65
Which two are types of port profiles? (Choose two.)
A. vEthernet
B. Ethernet
C. static
D. dynamic

Correct Answer: AB QUESTION 66